St. Louis Chapter Meeting - How to Use Your Lab Scope by Mark Ingram

Description

SOLD OUT
How to Use Your Lab Scope
sponsored and presented by Mark Ingram, Garage Gurus
Hands-On Training - Limited Space Available

In this workshop we present how to set up and operate a lab scope for the purpose of testing automotive sensors and components of various types. We cover set up procedures, voltage and time base settings, and waveform capturing techniques. Waveform analysis is discussed on many different captures to differentiate ‘good’ and ‘bad.’ Several on-car demonstrations take place in our state-of-the-art service bays during this workshop. After completing this workshop, the student will have the knowledge to:
• Set up and capture automotive waveforms using a lab scope
• Configure lab scope settings for optimized viewing of waveforms
• Properly connect a lab scope to various solenoids, actuators, speed and position sensors, and DC motors found under hood
and undercar
 
This is a class with extensive hands-on exercises using both PICO and Snap-On scopes. We demonstrate:

• Relative Compression
• Coil-on plug secondary
• Triggering with #1 primary ignition for cylinder identification
• Basics of current ramping
• Fuel pump amperage pattern diagnosis

Above all, we show the practical application of these time-saving techniques, not just “Pie in the Sky” theory.

View More St. Louis Training Events Here!